Schneider Automation Modicon Quantum Ethernet Uživatelská příručka Strana 169

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 900
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 168
CPU Modules
35013379 02 October 2007 169
Rear Panel
Switches
Two rotary switches (see the following illustration and table) are located on the rear
panel of the CPU. They are used for setting Modbus Plus node and Modbus port
addresses.
SW1 (the top switch) sets the upper digit (tens) of the address; SW2 (the bottom
switch) sets the lower digit (ones) of the address. The illustration below shows the
correct setting for an example address of 11.
The following figure shows SW1 and SW2.
The following table shows the SW1 and SW2 address settings.
Note: The highest address that may be set with these switches is 64.
Note: If "0" or an address greater than 64 is selected, the Modbus + LED will be
"on" steady, to indicate the selection of an invalid address.
SW1 and SW2 Address Settings
Node Address SW1 SW2
1 ... 9 0 1 ... 9
10 ... 19 1 0 ... 9
20 ... 29 2 0 ... 9
30 ... 39 3 0 ... 9
40 ... 49 4 0 ... 9
50 ... 59 5 0 ... 9
60 ... 64 6 0 ... 4
1
3
0
9
2
6
4
5
8
7
1
3
0
9
2
6
4
5
8
7
SW1 (TOP)
SW2 (BOTTOM)
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com
Zobrazit stránku 168
1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 899 900

Komentáře k této Příručce

Žádné komentáře